Have a question ? Call: (916) 381-2222 or Email: sales@abejan.com

ASI 64696A-9 | ASI Surface Mounted Automatic Battery Operated Roll Paper Towel Dispenser and Waste Receptacle
American Specialty Surface Mounted Automatic Battery Operated Roll Paper Towel Dispenser and Waste Receptacle: shall hold and dispense one 8" diameter (?203) x 8" wide (203) standard towel roll up to 800 ft. (244m) long and one 8" wide (203) stub roll up to 4" diameter (?102) and shall have a waste capacity of 9.4 gallons (36 liters).

- Automatic Touchless Roll Towel Dispenser shall be powered by four (4) D-size batteries (not supplied) and shall operate automatically to activate towel dispensing when hands are placed in sensor zone.
- At each activation unit shall feed out a length of towel selected by owner by setting length, delay and paper saver switches. Unit shall have an internal towel cut-off bar.
- Towel dispensing opening shall have a fully deburred edge for snag free dispensing and user safety.
- Full-face door, cabinet, dispenser and waste receptacle shall be fabricated of type 304 stainless steel alloy 18-8. All exposed surfaces shall have a satin finish and shall be protected during shipment with PVC film easily removable after installation.
- Door shall be fabricated of 18 gauge, fabricated from one piece, with no miters, welding or open seams on face and have 1/2" (13) square returns to the wall.
- Cabinet shall be 20 gauge with a 1" (25.4) wide perimeter trim to lay flush against wall. Unit back plate for mechanism shall be fabricated of same grade 18 gauge.
- Door shall be attached to the cabinet body with a full length 3/16" diameter (?4.8) stainless steel multi-staked piano hinge and shall be held closed with two (2) tumbler locks keyed alike to other ASI washroom equipment.
- Waste container shall have hemmed edges for safety and a finger grip for easy removal.
- Structural assembly of all components shall be of welded construction.
- Wall Opening: 14 5/8" x 39 5/8" x 9 1/8"

Installation:
- Mount unit on wall with ¹ 10 self-tapping screws (by others) through concealed mounting holes provided.
- For compliance with ADA Accessibility Guidelines, install unit so that top edge of towel dispenser opening is 48" (1219) maximum above finished floor (MAX AFF).
- SM collar is installed on cabinet prior to mounting on wall following procedure described on SM Collar Data Sheet.
- Sensor ground wire must be connected inside cabinet.

Operation:
- Towels are dispensed one at a time automatically when hands are placed in sensor zone until supply is depleted.
- Owner predetermines length of towel dispensed by making selections on three (3) three-position switches for length, delay, and economy.
- Unit may be reloaded with a full roll to automatically start when finished with an existing partial roll and will continue to feed properly when reloaded with a full roll and partial roll is transferred to stub roll position.
- Refill dispenser by unlocking door and replacing towel roll for an empty or partially empty unit.
- Dispenser supply is replenished, batteries are replaced and waste receptacle is emptied manually on cycles determined by maintenance needs.
- LED indicates sensing and battery condition. Locking full-face door over compartments prevents unauthorized access or removal.